Waterproofing Your Basement can be Done by DIY.

Since a significant amount of homeowners who own basements are also subjected to water leaks, it’s understandable that there is such a great demand for information and products associated with DIY basement waterproofing.

The first thing that we have to see is the cause of basement water seepage and flooding. Extra moisture in the lower level of your house can make space unusable as well as create structural problems and destroy your belongings.

A large hole is dug in the ground to install a basement. Once the walls and floor of the basement are built, the remainder of the hole is filled in with effectively, loose soil, even if it’s compacted afterwards. The loose soil around the basement provides the least resistance to water and it will use this path to seep into that area. The end result of this is likely to be that you will find that there is an accumulation of water either surrounding or even underlying your basement.

Hydrostatic pressure is created by this on the basement walls and floors. Without adequate basement waterproofing, water will seep through even the smallest crack which then ruins the outside protective coating. No system is foolproof, because even those that remove water from the building, can’t always prevent silt and heavy rainfalls from blocking pipes and causing system overload.

It’s at this point that many people turn to do it yourself basement waterproofing rather than have the basement completely excavated and re-done, usually at great expense. Many people solve the problem by using sealants and similar products inside on the floor and walls.

A typical project might involve:

the walls are prepared by removing all loose or crumbled material.
Previous repair or foreign material must be removed.
- make sure the basement is as dry as possible, hire heaters or large fans if necessary.
- prime walls and floor if the product requires use of a primer.
repair all easily seen gaps, flaws, seams, or joints.
A 1″ bead of sealant is used on the wall and floor junctions.
- top-coat all surfaces with the final product, using 2 or 3 coats as appropriate.

There’s nothing more to it. If the product is a good one you will have a sealed basement that should last for a number of years. Top sealants such as PermaFlex are supposed to be a complete, permanent indoor basement waterproofing system. The quote says that it is the only waterproofing system which totally seals any basement for all times. It could be very wet and deteriorated though. It can then be brushed, rolled over or even be sprayed on.

A complete solution would cost the average homeowner hundreds of Dollars for a good-sized basement rather than thousands, is perfect for do it yourself basement waterproofing and is a great budget-conscious solution for a common and potentially expensive problem.

Share This